Batteries and charging

Stairlift battery problems: charging first, then the battery

Stairlift battery problems are usually charging problems first. The makers' manuals all say the same thing in different words: a stair lift runs on its batteries and tops them up while it is parked where it can charge, with the power on. So a lift that runs down, beeps or will not climb is most often parked in the wrong place, switched off somewhere, or recovering from a power cut. Only when those are ruled out are the batteries themselves the suspect.

Last checked: , against the makers' own documents Published by SEO Dons Ltd

Is it charging at all?

Most lifts tell you. Learn what your model shows when it is charging and you can check in seconds.

How each model shows it is, or is not, charging
ModelChargingNot chargingSource
Acorn 130C1 rising to C5; C6 when full; one beep on arrivalA1 with beeping130 manualpp.18, 24
Acorn 180C1; C4 when fullA1 flashing with beeps180 manualp.11
Handicare 1100No charging code is printed; 1 means it needs charge2, with 40 seconds of beeps1100 manualpp.21, 26
Handicare 1000No charging code is printed; 1 means it needs charge2, with 15 seconds of beeps; r is a supply fault1000 manualpp.8, 25, 27
Handicare FreecurveLamp on the charging cable box orange; green when fullThree minutes of beeps, armrest lamp flashingTechToolweb page
Stannah 6002: no fault found1: charging or battery fault600 support pageweb page
Stannah 260, 420Quiet when parkedBeeping while parked260 guidep.25

The charging causes, in order

1. Where it is parked

On curved lifts, and on Acorn's 130 and Handicare's 1000, charging happens only at charge points, usually the top and bottom of the rail, sometimes also part way (Acorn's 180 has an intermediate point when a hinge is fitted). A chair that stopped a few centimetres short will not charge. Handicare's 1100 manual mentions no charge points; its charging check is the plug. Stannah's beeping page says a straight Stannah charges wherever it stops on the rail, but a curved one needs to be right at its charge point (Stannah beeping pageweb page). Acorn's instruction is blunt: whenever the lift is not in use, leave it on a charge point.

2. The power to the charge point

The socket or wall switch feeding the lift must stay on. Acorn wants a socket used only by the stair lift and the supply left permanently connected; Handicare's manuals say never to take the lift's plug out of the wall socket; Stannah's battery page says not to turn off the power at the socket or spur, because that drains the batteries and shortens their life (Stannah batteries pageweb page).

3. The lift's own switches

Some lifts have a switch of their own between the batteries and everything else. On an Acorn 130 it is the battery isolation switch on the carriage, which Acorn says must stay on at all times or the batteries lose their charge, at the owner's cost (Acorn 130 manualp.10). Stannah's lifts have a master power switch, normally left on. Handicare's 1000 has an on/off button on the front of the unit.

4. A power cut

During a power cut nothing charges, and the lift runs on what is in the batteries. Stannah says fully charged batteries are good for at least 15 to 20 trips up and down; Acorn says several journeys. After a long cut, let the batteries recharge before relying on the lift again, as Acorn's 180 manual advises. There is more on stair lifts after a power cut.

Low-battery codes

When the charge runs low, most lifts change their behaviour before they stop. An Acorn showing E7 will still go down but not up until it has recharged, and if that is ignored the F5 alarm follows. A Handicare 1100 showing 7 has too little voltage to ride, and its manual says to wait about 30 minutes before the next trip (Handicare 1100 manualp.22). Handicare's 1000 and Freecurve manuals say the lift does not work at all once its batteries are flat. Stannah says its lifts give no alarm or flashing light when the batteries run low; they simply slow down. The codes are all in the stair lift error code library, and the beeps that go with them on stair lift beeping.

Signs the batteries are worn

Stannah lists three signs that a battery is near the end of its life: the lift runs slower than usual, or slows as it climbs; it stops after a short distance and then carries on; or it will not charge at its usual charging point, which Stannah says means the battery is completely drained (Stannah battery typesweb page). It adds that once a battery cannot hold enough charge it has reached the end of its life and must be replaced. Acorn's manuals describe the other way batteries die early: left without power for long enough, they become too low to recharge, and then have to be replaced by an engineer, outside the warranty and as a chargeable job.

Batteries are not an owner's job

Stannah tells owners never to replace a stairlift battery themselves; Acorn says an engineer replaces them. The batteries sit inside the lift's covers, which this guide never asks you to open. Stair lift battery replacement sets out what each maker says.

Going away, and switching off

Makers differ on what to do before a long absence. Stannah's 600, 260 and 420 guides say switch off both the master power switch and the wall switch so the batteries are still charged when you return, while its battery page suggests leaving the lift on and having someone ride it now and then. Handicare's current 1100 manual asks owners with the optional on/off switch to switch the lift off during a power cut across the house, to stop its batteries draining (Handicare 1100 manualp.3). Where your model's guide gives an instruction, follow that one.

When to call

If the lift is on its charge point with the power on and still shows it is not charging, or keeps falling back to a low-battery code after full charges, the owner checks are used up. Acorn sends charger faults (C7, C8, C9) to its dealer; Handicare's code pages say call Handicare; Stannah says your local service branch will need to replace the batteries at any of its warning signs. How long batteries usually last is on how long stair lift batteries last, and where each make charges is on charging points. The repair quote form above sends the make, model and symptom to SEO Dons Ltd, which replies by email.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote