Acorn · troubleshooting

Acorn stairlift problems and what Acorn says to check

Acorn stairlift problems usually show up on the lift's own display before you notice anything else, so the code is the place to start. Acorn publishes user manuals for two models on its website: the Superglide 130 for straight stairs and the 180 for curved ones. Both manuals give owners a short list of checks (the power switch, the key, the charge point, the seat and anything in the way) and send everything else to an authorised Acorn dealer.

Last checked: , against the makers' own documents Not affiliated with any manufacturer

Find your Acorn model

Not sure which you have? A straight rail and a display next to the key point to the 130; a rail that turns corners and a display under the seat point to the 180. The model is also on the cover of the user manual that came with the lift.

Won't turn on

A dark display means the lift has no power or has gone to sleep. On the 130, Acorn's two checks are the battery isolation switch, which sits on the wall side or rear of the carriage cover and should always be on, and a press of the armrest paddle to wake the lift (Acorn 130 manualp.24). On the 180, turning it on takes the key turned clockwise and the switch pushed until its green light shows (Acorn 180 manualp.8); a remote or the controls wake it from sleep. If the display stays dark after that, Acorn gives no further owner step.

Won't move

Look at the code. On a 130, E9 means the key is out or turned off, E6 that the seat is not locked in its riding position, and E1, E2, E4 or E5 that a safety edge has been pressed. On a 180, E1 to E5 are its five safety edges and E6 is the seat. Both models stop climbing with E7, a low battery, and will only go down until it has recharged. Both also need the arms lowered: the 180 manual says so in as many words, and the 130's list of safety features includes a "downside arm interlock" that will not let the lift run with the arms up. The full set is on Acorn error codes.

Beeping

An Acorn beeping while parked is not charging: it is off its charge point, the mains is off, or the batteries are flat. The 130 and 180 settle into different sleep patterns after a minute or so, which the Acorn beeping page sets out side by side, along with the flat-battery alarm.

Keeps stopping

A lift that stops part way and shows an E code has met something with a safety edge. Acorn's answer on both models is to move the lift back the opposite way and remove the obstruction (Acorn 180 manualp.12). If it keeps happening with nothing in the way, that is an engineer's job, as is anything to do with the edges themselves. The 130 manual also warns that small objects can fall onto the rail and slide into the mechanism; if you think one has, it says to consult your Acorn representative before using the lift again (Acorn 130 manualp.5). Keeps stopping covers the other makes.

Remote does nothing

Acorn recommends a new battery in each handset every year. On the 130, the handset must point at one of the infrared sensors on the carriage, and some low-energy bulbs can interfere with it; the 180's handset takes a 9 volt PP3 battery and works only with the lift switched on and the seat facing forward. Remote not working has the details.

What Acorn asks of owners

The 130 manual asks owners to check three things every two months: that the lift works normally, that the safety sensors work, and that the rail and carriage are free of debris (Acorn 130 manualp.3). It asks for the rail to be wiped weekly with a dry cloth, never a damp cloth with an abrasive cleaner. And it asks owners never to disconnect the power: a lift left without power drains its batteries until it will not run (p.5). The yearly inspection Acorn requires is a dealer's visit, and outside this guide.

What Acorn's manuals describe that this guide leaves to engineers

Hand winding (the 130's answer to F6 and F7, and a warning on the 180), the electrical continuity test for H1 and H2, tapping a safety edge, the remote re-programming routine that presses an edge, and anything behind a cover. The code pages cite where each is printed and say to call an engineer.

Who Acorn says to call

Acorn's manuals name an authorised Acorn dealer or Acorn representative for every fault an owner check does not clear. If the lift is under a warranty or a service plan, start there. To ask for a repair quote instead, the form on this page sends the model and the code to SEO Dons Ltd, which replies by email. Stairlift Support is independent and is not affiliated with Acorn or any other manufacturer.

Other makes: Stannah, Handicare, Brooks, Minivator and thyssenkrupp Flow. Every manual linked on this site is in the manual finder.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote