Acorn Superglide 130 · straight stairs

Acorn 130 fault codes, checks and charging

Acorn 130 fault codes appear on a small two-character display next to the key switch on the carriage. Acorn's user manual for the Superglide 130 (control board T700, edition 1220) sorts them into five groups: C for charging, A for normal running, E for faults that stop the lift until you deal with them, H for hardware faults and F for what Acorn calls fatal errors. Most E codes have an owner check; the H and F codes mostly end with Acorn's authorised dealer.

Last checked: , against the makers' own documents Not affiliated with any manufacturer

Reading the 130's display

With the chair parked on a charge point, a healthy 130 shows A1 or one of C1 to C6. The manual says that if you see anything else, look the code up on its pages 24 to 27 (Acorn 130 manualp.11). A dark display is a code in its own right: either no power is reaching the lift or it has gone to sleep to save its batteries.

Two habits make the codes easier to read. First, look before you touch anything: the code shown when the lift stopped is the one that matters. Second, note whether the lift still moves at all. Acorn marks its C and A codes "lift will operate as normal" and its E, H and F codes "lift will not operate", so a lift that will not budge with an A code showing is worth mentioning when you ask for help.

Every code in the Acorn 130 manual, in short (full meanings and checks on the Acorn error codes page)
Shows In short The lift Where it says so
C1-C5 Charging Moves normally Acorn 130 manualp.24
C6 Fully charged Moves normally Acorn 130 manualp.24
C7 Charger voltage low Moves normally Acorn 130 manualp.24
C8 Charger voltage high Moves normally Acorn 130 manualp.24
C9 Battery not found or faulty Moves normally Acorn 130 manualp.24
blank No power, or asleep Depends Acorn 130 manualp.24
A1 Not charging, beeping Moves normally Acorn 130 manualp.24
A2 Going up (armrest) Moves normally Acorn 130 manualp.25
A3 Going down (armrest) Moves normally Acorn 130 manualp.25
A4 Going up (remote) Moves normally Acorn 130 manualp.25
A5 Going down (remote) Moves normally Acorn 130 manualp.25
A9 Moving the hinge Moves normally Acorn 130 manualp.25
E1 Footrest edge, down side Will not move Acorn 130 manualp.25
E2 Footrest edge, up side Will not move Acorn 130 manualp.25
E4 Carriage edge, down side Will not move Acorn 130 manualp.25
E5 Carriage edge, up side Will not move Acorn 130 manualp.25
E6 Seat not in riding position Will not move Acorn 130 manualp.25
E7 Battery low Will not move Acorn 130 manualp.26
E9 Key switch off Will not move Acorn 130 manualp.26
H1 Safety circuit 1 to chassis Will not move Acorn 130 manualp.26
H2 Safety circuit 2 to chassis Will not move Acorn 130 manualp.26
H3 Hinge not responding Will not move Acorn 130 manualp.26
H6 Hinge stuck part way Will not move Acorn 130 manualp.26
F1 Relay fault Will not move Acorn 130 manualp.26
F2 Brake fault Will not move Acorn 130 manualp.26
F3 Motor overcurrent Will not move Acorn 130 manualp.27
F5 Battery flat, alarm Will not move Acorn 130 manualp.27
F6 Final limit overrun Will not move Acorn 130 manualp.27
F7 Over-speed governor Will not move Acorn 130 manualp.27
F8 Down-side edge at the top Will not move Acorn 130 manualp.27
F9 Up-side edge at the bottom Will not move Acorn 130 manualp.27

For what Acorn says each one means, the owner check it gives and when it sends you to a dealer, see the Acorn error codes page, which sets the 130 beside the curved 180.

The ones owners usually meet

E9 is the commonest stop. The key has been taken out or turned to the left, and the lift will not run until it is back in and turned clockwise. Acorn notes that removing the key, which stops anyone else using the lift, does not stop it charging (Acorn 130 manualp.11).

A1 comes with beeping: the chair is somewhere other than a charge point, so nothing is topping up the batteries. Drive it to the top or bottom of the rail and check the mains has not been switched off.

E7 means the batteries are low. The 130 will still take you down but will not climb until they have recovered, so bring it to the nearest charge point and leave it there. If it is ignored, F5 follows: an alarm that one press of the armrest control or the remote silences, after which the job is the same.

E1, E2, E4 and E5 are the four safety edges: on the footrest and on the carriage, one facing up the stairs and one facing down. Something has touched one and the lift has stopped. Page 22 of the manual says the cure is usually to move the lift back the other way and take out whatever was trapped; if that does not work, it says to contact your authorised Acorn representative. E6 is the seat: it has been swivelled, and the lift will not move until it is turned back and locked for travel.

Charging and the battery on a 130

Acorn's instruction is blunt: when the lift is not in use, it must be left on a charge point (Acorn 130 manualp.18). On a standard rail those are at the top and the bottom, where the lift stops by itself, and it gives a single beep to show it has arrived. The mains supply, or the transformer, should stay plugged in and switched on all the time, and Acorn asks for a socket that serves the stair lift alone.

Two switches decide whether the batteries ever see that charge. The wall supply is one. The other is on the lift: the battery isolation switch on the wall side or rear of the carriage cover, which Acorn says must stay on at all times. Leave it off and the batteries lose their charge, which Acorn says its warranty terms do not cover (Acorn 130 manualp.10).

In a power cut the 130 keeps going for several journeys and then stops when the batteries run down. The manual warns that a long spell without power can leave them too low to recharge; at that point an engineer has to replace them, which the manufacturer's warranty does not cover and Acorn charges for. That is the 130's battery replacement in a sentence: it is an engineer's job, and the way to put it off is to keep the lift parked and powered. The battery replacement page sets this beside what other makers say, and after a power cut covers the outage itself.

Acorn's reset

The 130 has an owner reset: switch the battery isolation switch off, leave it for 30 seconds, switch it back on. Acorn says this resets the control board and clears the fault codes on the display (Acorn 130 manualp.22). Its code table asks for the reset for three fatal errors, F1, F2 and F3, and for F2 adds an hour on a charge point. If a code comes straight back after a reset, the manual's next step is the dealer, not another reset. The reset page compares this with Stannah's key restart.

Remote handsets

Each handset has two buttons, red and green or up and down, and must point at one of the two infrared sensors on the carriage: the top one near the display, the bottom one on the bottom plate by the rail (Acorn 130 manualp.12). The armrest paddle always overrides a remote. Acorn recommends a new battery in each handset every year, and gives two reasons a remote can misbehave: outside interference, which can stop the lift until the button is released and pressed again, and some low-energy light bulbs, which give off infrared light that confuses the sensors (Acorn 130 manualp.21).

Page 21 also describes how to re-programme a handset that has lost its programming. It involves pressing a safety edge on the carriage while the key is out, so this guide does not set it out: follow Acorn's page exactly, or ask an engineer. More on handsets is on remote not working.

If the 130 stops on the stairs

Someone hurt or unable to get off: call 999

Then follow Acorn's own steps below only if they can be done safely.

Acorn's advice is to stay calm with both arms down, release the direction control on the armrest, then press it again in the opposite direction (Acorn 130 manualp.28). Getting off part way is a last resort. If it has to happen, the manual says to swivel the seat towards the stairs using the lever at the side of the seat, make sure it has locked, and undo the seat belt only once the seat faces the stairs and is locked (p.29). The manual's hand-winding procedure on page 20 is for engineers here, whatever a video suggests. The stuck on the stairs page covers the person first.

When Acorn sends you to the dealer

Read across the code table and the dealer, or an engineer, is the answer for: the charging faults C7, C8 and C9; the hinge faults H3 and H6 once the mains and any obstruction have been checked; F1, F2 and F3 when a reset has not cleared them; and every code whose printed remedy is a job inside the lift. H1 and H2 call for an electrical continuity test, and F6 and F7 for hand winding; none of those is an owner's job. Acorn's safety page adds one more: if you think something has dropped down the rail into the mechanism, consult your Acorn representative before using the lift again (p.5).

The manual itself

Acorn publishes the 130 user manual on its own website as a multilingual PDF; English is printed pages 3 to 36, the codes are on pages 24 to 27 and the wiring diagrams that follow them are for engineers. The manual finder links Acorn's copy with the edition checked. This page was written from that copy, read in full on the date shown above.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote