Batteries and charging

Stairlift charging points: where each make charges

A stairlift charging point is where the lift tops up its batteries from the mains, and where it is matters. Most lifts in this guide charge only at points at the top and bottom of the rail, with an extra point part way on some. A straight Stannah is the exception: Stannah says it charges wherever it stops on the rail. Each maker's manual also says how to tell the lift has reached a charging point, from a single beep on an Acorn to a lamp on a Handicare's charging cable box.

Last checked: , against the makers' own documents Published by SEO Dons Ltd

Where each make charges, and how you can tell

Charging points and charging signs, as the makers describe them
ModelWhere it chargesHow you can tellSource
Stannah 600 (straight)Anywhere on the rail, Stannah says; the charger sits at the top or bottom of the stairsDisplay shows 2, not 1Stannah beeping pageweb page
Stannah 260 (curved)Charge points, usually at the top or bottom of the railIt stops beeping; a beeping parked lift is not chargingStannah 260 guidepp.7, 25
Acorn 130Top and bottom of a standard rail, where it stops by itselfOne beep on arrival; C1 to C5 while charging, C6 when fullAcorn 130 manualpp.18, 24
Acorn 180Top and bottom, and an intermediate point if a hinge is fittedC1 charging, C4 full; A1 flashing means not chargingAcorn 180 manualp.11
Handicare 1000Top and bottom of the rail; there may be moreOff the right position it beeps for 15 seconds and shows 2Handicare 1000 manualp.8
Handicare FreecurveTop and bottom of the rail; there may be moreCharging cable box lamp orange while charging, green when full; three minutes of beeps if it is off positionHandicare TechToolweb page
Handicare 1100The manual names no charge points; its charging check is the plug2 and 40 seconds of beeps when it is not rechargingHandicare 1100 manualp.21

Acorn stairlift charging points

Acorn's instruction is that a lift not in use must be left on a charge point, and that where the points are depends on the rail fitted (Acorn 130 manualp.18). On the 130's standard rail they are at the top and bottom, where the lift stops automatically, and the power reaches the lift from the mains or a transformer through them. The lift gives a single beep when it arrives, and the display should then show A1 or a C code. The 180's points are fed from the mains through a DC power supply; if a hinge is fitted there is an intermediate point too, and Acorn says not to leave the lift part way up unless it is at one of those (Acorn 180 manualp.15).

Stannah stairlift charging points

Each Stannah guide shows a battery charger positioned at the top or bottom of the staircase. On a straight 600, Stannah's beeping page says the lift charges wherever it is on the rail; on a curved lift such as the 260, only at its charge points, so a chair stopped just short beeps until it finishes its travel. The fix Stannah gives is to press the wall control towards that end. With a hinged rail, the lift must also be sent back up so the rail is raised, which the 260 guide says makes sure it is on charge. The 600 guide gives the charger's rating: input 100 to 240 volts AC, output 24 volts DC at 750 milliamps (Stannah 600 guidep.18).

Handicare stairlift charging points

Handicare's 1000 and Freecurve manuals put charge points at the top and bottom of the rail and say there may be more. Park the Freecurve by holding the remote's button until it reaches a charge point; it stops by itself and the remote's lamp goes out (Freecurve manualp.10). Both manuals say the lift does not work once its batteries are flat. TechTool adds the charging cable box lamp on the Freecurve, and about two hours for a full charge.

The power to the charging point

A charging point only works if the mains reaches it. TKE says its lifts need a power supply for the charging point so the battery can charge while parked (TKE questionsweb page). Acorn asks for a socket used only by the stair lift, left permanently connected and switched on. Handicare's manuals say never to take the lift's plug out of the wall socket. Brooks says its batteries charge whenever the lift is not in use.

Leave the contacts alone

No maker read gives owners a step that touches the charging contacts, the strips on the rail, or the charger itself. If a charging point looks damaged, or the lift will not charge on it with the power on, that is for an engineer.

If it will not charge on its charging point

Check the wall switch, any switch on the lift (Acorn's battery isolation switch, Stannah's master power switch, Handicare's on/off button), and whether there has been a power cut. Then look at the display or lamp. Charging faults the makers name include Acorn's C7, C8 and C9 and Handicare's r and U; all of those go to the maker or an engineer. More on battery problems, the beeps on stair lift beeping, and the codes in the error code library. The repair quote form at the foot of this page reaches SEO Dons Ltd, which replies by email.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote