Stannah model 600 · straight stairs

Stannah 600 stairlift: codes, checks and the battery

The Stannah 600 stairlift is Stannah's model for straight stairs and, of the Stannah models covered here, the only one whose guides print numbered fault codes. A display on the side of the carriage shows a number from 1 to 9, or F; Stannah's 600 guides and its 600 support page explain each one and, for most, give the owner a check. Code 2 means no fault found. Codes 9 and F mean a service engineer is needed. There is no code 8 in any of them.

Last checked: , against the makers' own documents Not affiliated with any manufacturer

The codes on a 600

All three 600 guides, for the Siena, Starla and Sofia or Solus chairs, print the same table on page 22, and Stannah's 600 support page repeats it with more detail (Stannah 600 support pageweb page). Stannah says the codes are there so that, in most cases, owners can sort out a common problem without calling an engineer out.

Stannah 600 display codes and status lights, in short (full meanings on the Stannah error codes page)
Shows In short The lift Where it says so
1 Charging or battery fault Depends Stannah 600 guidep.22
2 No fault found Moves normally Stannah 600 guidep.22
3 Something at the footrest or carriage Will not move Stannah 600 guidep.22
4 Power key or on/off switch Will not move Stannah 600 guidep.22
5 Seat sensor or downside arm Will not move Stannah 600 guidep.22
6 Immobiliser seatbelt Will not move Stannah 600 guidep.22
7 Seat not in travelling position Will not move Stannah 600 guidep.22
9 or F Engineer needed Will not move Stannah 600 guidep.22
LED off Master switch off Will not move Stannah 600 guidep.22
LED pulsing Key or on/off switch Will not move Stannah 600 guidep.22
LED on Ready Moves normally Stannah 600 guidep.22

The guide prints code 1 as "-/1". The status-light rows come from the Starla guide. Full meanings, Stannah's checks and its engineer point: Stannah error codes.

Code 8, and other codes that are not there

People search for "Stannah 600 fault code 8", but the 600 guides list 1 to 7, then 9 and F, with nothing for 8, and Stannah's 600 support page has no 8 either. Nor is there an H. If your 600 shows a code that is not in the table, this guide has no meaning to give: tell your Stannah supplier the code and the model number, which the guide says is on a label on the carriage (600 Siena guidep.24).

Key and switches, chair by chair

The 600 comes with different chairs, and the key works differently on them. On a Siena or Starla chair the keyhole is on the side of the chair and the key has to be pushed fully in; with the key in and the on/off switch on, the light on the switch comes on (600 Siena guidep.10). On a Sofia or Solus chair the key goes into the end of the control pod and turns to on, and a green power light on the armrest shows it is on (600 Sofia/Solus guidep.10). Behind both is the master power switch on the back of the base of the chair, which Stannah says should normally be left on: the lift will not work with it off. And at the socket there is the wall switch, which also stays on.

The Starla guide adds a reading of the power light. Off means the master power switch is off; pulsing means the key is not in properly or the on/off switch is off; steady means the lift is ready. A pulsing light is also how a Siena or Starla chair looks when it has been switched off at the on/off switch with the key left in.

The few seconds' wait is not a fault

A 600 does not move the instant you press the arm control. Stannah's guides say you move and hold the control and the lift sets off after a few seconds, and call the delay a safety feature (600 Siena guidep.15). Let go at any point and it stops. The same goes for the remote calling controls at the top and bottom of the stairs: once you release the arrow, the lift will not start again for a few seconds (p.11). On chairs with the seat sensor, the Starla guide notes the arm control works only with someone sitting on the seat, though the remote calling controls still work with it empty (600 Starla guidep.7).

If it will not move, or stops

Read the code first, then use the guide's own restart if you still need to get down. It has two steps: take the power key out and put it back, then move and hold the control downwards; after a few seconds the lift should start. If it stops again, repeat both steps until you reach the bottom, then call your Stannah supplier (600 Siena guidep.23). If the restart does not work, Stannah says to ask another person in the home to contact your supplier, and recommends carrying a mobile phone when you use the lift alone. Only as a last resort does it suggest swivelling the chair towards the top of the stairs, undoing the seatbelt and getting off up the stairs.

Hurt, or unable to get off safely: call 999

The guide's "last resort" is for someone who is safe and able to do it. The 600 guide also describes an emergency drive behind an access door; this guide leaves that to an engineer.

Stannah's guides also say never to try to dismantle the lift. The stuck on the stairs page puts all of this in order, person first.

Remote calling controls

The 600's remote calling controls sit at the top and bottom of the stairs, run on three AA batteries each and, Stannah says, last about a year with average use (600 Siena guidep.19). Press an arrow and the light around the buttons shows the battery state: lights rotating is fine, lights on all the time means change the batteries soon, no light means they are flat. The controls also need the lift switched on at its on/off switch. More on remotes that do nothing.

Batteries and charging on a 600

The 600's battery charger sits at the top or bottom of the stairs (600 Siena guidep.7), and Stannah's beeping page says a straight stairlift charges wherever it stops on the rail. So charging problems on a 600 usually come back to the switches: Stannah's support page answers code 1 by asking you to check the wall switch and the master power switch, both of which should always be left on, and then whether there has been a power cut.

Stannah's battery pages describe its lifts as running on two 12 volt, 7.4 amp-hour valve-regulated lead-acid batteries in series (Stannah battery typesweb page). They give two battery lives: around 2 to 5 years on the troubleshooting page and around 3 to 5 years on the battery-types page, both depending on use. The signs Stannah lists for worn batteries are a lift that runs slower than usual, one that stops after a short distance and then carries on, and batteries that will not charge at the usual point.

On Stannah 600 battery replacement, Stannah is direct: never attempt it yourself, as it risks voiding your cover, and leave it to a trained engineer (Stannah batteries pageweb page). It publishes no battery price, and says to ask your local Stannah office or dealer. The battery replacement page compares the makers, and how long batteries last has each maker's figure.

Going away

For a longer absence, the 600 guides say you can switch off both the master power switch and the wall switch, and that switching off both is what keeps the batteries charged for your return (600 Siena guidep.9). Stannah's battery-types page gives different advice for the same situation: leave the lift on, and if you can, have someone ride it while you are away. Where the two differ, the guide for your model is the one to follow.

The 600 guides

Stannah publishes a guide for each 600 chair on its own website: Siena, Starla and Sofia or Solus, each Issue 7, November 2022. The codes, switches and help pages are the same in all three apart from the key and the code 5 wording. The manual finder links each, and the Stannah page covers the 260 and 420.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote