Stannah model 260 · curved stairs

Stannah 260 stairlift: checks from Stannah's own guide

The Stannah 260 stairlift is Stannah's model for stairs with turns, and its guides work differently from the straight 600's: there is no list of numbered codes. Instead the guide reads the lift by its power light and by what it is doing, beeping or refusing to move, and gives a short checklist for each. The answers below come from the 260 guides and Stannah's 260 support page, each tied to its page.

Last checked: , against the makers' own documents Not affiliated with any manufacturer

"Stannah 260 LED 5" and other codes

People search for LED and fault numbers on a 260, but none of Stannah's public 260 guides prints one. That is true of the Siena, Starla, Sofia and Solus, Sarum and Saxon guides and of the Sadler standing lift, and Stannah's 260 support page gives the same checklists rather than codes (Stannah 260 support pageweb page). So this guide gives no meaning for "LED 5" on a 260. If your lift shows a number, give it and the model number to your Stannah supplier: the model is on the lift's product label, shown on page 26 of the guide.

Start with the power light

The 260 has an on/off switch with a light in it. Stannah splits its checks on whether that light is on (260 Siena guidep.24). Off means the lift is not switched on: the master power switch, which on the 260 is on the front of the chair and normally left on, or the power key, which goes in the keyhole on the front of the chair and turns to on. On means power is reaching the chair, so something else is holding it: the seat, an obstruction or the hinged rail.

Two other things stop a 260 that are not faults. The seat must be turned back to its travelling position with the swivel levers fully down; the guide notes the manual swivel only turns towards the top of the stairs, as a safety feature (p.16). And the guide says the lift will not start until the seatbelt is fastened (p.14).

The checklists, as Stannah gives them

Beeping while it is not being used

What the maker says it means: The batteries are not being charged. The lift can keep running on its batteries for now.

  • The wall switch is on (page 9 of the guide shows where it is).
  • There has not been a power cut in the house.
  • The chair is right at the top or the very bottom of the stairs, where it charges.

If that does not work: If it still beeps after the on/off switch has been used, contact your Stannah supplier. If you cannot clear it, turning the master power switch off silences the beeper; then call your supplier.

Stannah 260 guidep.25

Will not move, and the power light is on

What the maker says it means: Power is reaching the chair, so something is stopping it from setting off.

  • The seat is swivelled back to its travelling position and the swivel levers are pushed fully down (Stannah's 260 page marks the levers as a Sofia and Solus point).
  • Nothing is pressing on the safety edges. If something is, the lift can be moved the opposite way so you can take it out, then you can carry on.
  • If a powered hinged rail is fitted, it is fully lowered.
  • Turn the on/off switch off and back on.

If that does not work: If it beeps when switched back on, contact your Stannah supplier.

Stannah 260 guidep.24

Will not move, and the power light is off

What the maker says it means: The lift is not switched on: it will not work with either the master power switch or the power key off.

  • The master power switch is on. On the 260 it is on the front of the chair and is normally left on (page 9).
  • The power key is in and turned to on (page 10). The green power light on the armrest shows the key is on, says Stannah's 260 page.

If that does not work: If neither brings the light on, call your Stannah supplier.

Stannah 260 guidep.24

Stops, or still will not move after those checks

What the maker says it means: Stannah gives a short restart for getting the chair to the bottom of the stairs.

  • Turn the power key to off, then back to on.
  • Push and hold the control in the downward direction; after a few seconds the lift should start.
  • If it stops again on the way, repeat both steps until you reach the bottom.

If that does not work: Once down, call your Stannah supplier and ask for an engineer. If the restart does not work, get someone else in the house to call your supplier (page 24).

Stannah 260 guidep.24

The remote calling controls do nothing

What the maker says it means: Flat batteries in the handset are the usual cause. They last about a year with average use.

  • Press an arrow: rotating lights mean the batteries are fine, lights on constantly mean they are low, and no light means they are flat.
  • Each handset takes three AA batteries; the guide shows how to change them.
  • On a lift with a hinged rail, Stannah's 260 page says a flashing green light means low batteries and no light means none left.

If that does not work: If new batteries do not bring the handset back, contact your Stannah supplier or local branch.

Stannah 260 guidepp.20-21

Why a 260 beeps at the bottom of the stairs

A curved Stannah charges only at its charge points, and Stannah's beeping page says these are usually at the top or bottom of the rail. A 260 that beeps while parked is usually not charging. If yours has the optional powered hinged rail, there is a second reason: the guide says a lift left at the bottom of the stairs will start to beep, because the lowered hinge may be blocking a doorway and the lift is not on charge (260 Siena guidep.13). Holding the up arrow on a remote calling control until the hinged rail is fully raised moves the lift to where it charges. The hinged rail also flashes a light and beeps while it is moving, which is a warning and not a fault.

If the beeping will not stop, the guide allows one more owner step: turning the master power switch off silences the beeper. It is a stop-gap, not a fix, because the batteries are then not charging; the guide's next words are to call your Stannah supplier (p.25). Stannah beeping sets the 260 beside the 600 and 420.

If it stops on the stairs

If someone is hurt or cannot get off safely, call 999

The restart below is Stannah's, for someone who is safe on the chair.

Stannah's 260 support page gives the restart for a lift that keeps stopping: turn the power key off and back on, then push and hold the control downwards; after a few seconds the lift should start. Repeat until you reach the bottom and can get off safely, then call your local branch and ask for an engineer (Stannah 260 support pageweb page). If it will not restart, the guide says to get someone else in the house to call your supplier, and, only as a last resort, to swivel the chair towards the top of the stairs, undo the belt and get off up the stairs (p.24). The guide also describes a hand-winding tool for moving a stopped lift; this guide leaves that to an engineer, and Stannah warns never to use the lift with the tool in place. Stuck on the stairs covers the person first.

Remote calling controls on a 260

The controls at the top and bottom of the stairs take three AA batteries each and last about a year with average use (260 Siena guidepp.20-21). Press an arrow and the lights show the state: rotating is fine, on all the time means low, none means flat. On a lift with a hinged rail the handset is different, and Stannah's 260 page says a flashing green light means low batteries and no light means none left. If you let go of an arrow, the lift stops and waits a few seconds before it will start again. More on remotes that do nothing.

Batteries on a 260

Stannah's battery page says a model 260 on a staircase of 12 metres or longer, or a heavy-duty lift, runs on two 12 volt, 12 amp-hour batteries rather than the usual 7.4 amp-hour pair (Stannah battery typesweb page). Whichever it has, Stannah's advice is the same: keep the lift on its charge point and switched on, and leave battery changes to an engineer. For a long absence the 260 guide says to switch off both the master power switch and the wall switch, so the batteries are still charged when you return (p.9). See battery problems and how long batteries last.

The 260 guides

Stannah publishes a guide for each 260 chair: Siena (Issue 6, November 2023), Starla and Sadler (Issue 5, November 2022), Sofia and Solus (Issue 10, November 2022) and Sarum and Saxon (Issue 7, April 2011). Their Help pages agree; the chair-specific details, such as where the key goes, differ. The manual finder links each one, and the Stannah page covers the 600 and 420.

Where this comes from

Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.

Get a stair lift repair quote

For when the maker's manual says it is a job for an engineer. Give the make, the model and what the lift shows or does. Replies come by email, so this is not the way to get help for someone stuck on a lift now.

After you press send

  1. SEO Dons Ltd, which publishes Stairlift Support, receives what you send.
  2. Someone reads the make, the model and the fault, and replies by email.
  3. There is no obligation: asking does not commit you to any repair.
Add the model and the exact code, light or beep (optional)

Stairlift Support is published by SEO Dons Ltd, which has no engineers and no link to any stair lift maker. Answers come by email. Someone stuck on a stair lift who is hurt or in danger needs 999, not this form. How details are used: privacy notice.

Get a stair lift repair quote
Get a stair lift repair quote