Switching it on, and what the display should say
The 180's quick guide has two steps to turn it on: insert the key and turn it clockwise, then push the switch until its green light shows (Acorn 180 manualp.8). Both arms must be fully down before the armrest control will move it, although a remote can still call it with the arms up. Once it is on and parked, the display should read C1 while the batteries charge and C4 once they are full. A blank display means the lift is switched off or asleep.
| Shows | In short | The lift | Where it says so |
|---|---|---|---|
| blank | Off or asleep | Depends | Acorn 180 manualp.16 |
| A1 | Ready, not charging | Moves normally | Acorn 180 manualp.16 |
| A2 | Going up (arm switch) | Moves normally | Acorn 180 manualp.16 |
| A3 | Going down (arm switch) | Moves normally | Acorn 180 manualp.16 |
| A4 | Going up (remote) | Moves normally | Acorn 180 manualp.16 |
| A5 | Going down (remote) | Moves normally | Acorn 180 manualp.16 |
| A9 | Waiting for the hinge | Moves normally | Acorn 180 manualp.16 |
| C1 | Charging | Moves normally | Acorn 180 manualp.16 |
| C4 | Fully charged | Moves normally | Acorn 180 manualp.16 |
| E1 | Footrest edge, down side | Will not move | Acorn 180 manualp.16 |
| E2 | Footrest edge, up side | Will not move | Acorn 180 manualp.16 |
| E3 | Under-footrest edge | Will not move | Acorn 180 manualp.16 |
| E4 | Carriage edge, down side | Will not move | Acorn 180 manualp.16 |
| E5 | Carriage edge, up side | Will not move | Acorn 180 manualp.16 |
| E6 | Seat swivelled | Will not move | Acorn 180 manualp.16 |
| E7 | Battery low | Will not move | Acorn 180 manualp.16 |
| F5 | Battery flat, alarm | Will not move | Acorn 180 manualp.16 |
| F7 | Do not hand wind down | Will not move | Acorn 180 manualp.16 |
The full meaning of each symbol, the check Acorn gives and its engineer point are on the Acorn error codes page, set against the 130's.
Where the 180 differs from the 130
Anyone who has used an Acorn 130, or read a code list written for one, should know three differences. C4 is "fully charged" on the 180, whereas on the 130 it is only a step on the way from C1 to C5. The 180 has an E3, for a fifth safety edge under the footrest plate, which the 130's table does not list. And the 180's table stops at F5 and F7: the relay, brake and motor faults, the H codes and E9 that the 130 shows are not in the 180's manual at all. A code missing from the 180's own table has no published meaning for this lift, whatever it means on another model.
The five safety edges
The manual numbers them: one on each side of the carriage, one on each side of the footrest and one underneath the footrest (Acorn 180 manualp.12). If any of them meets an obstruction the lift stops at once, and the display shows which edge with E1 to E5. Acorn's instruction is to move the lift back the opposite way and remove the obstruction. Before you set off it also asks you to check the staircase is clear. If the lift keeps stopping with nothing in its way, that is a job for an engineer; this guide never suggests pressing, taping or adjusting an edge. Keeps stopping covers this across the makes.
Charging, beeps and the battery
The 180 charges at its parked positions: the top and bottom of the stairs, or an intermediate point if a hinge is fitted, with the charging points fed from the mains through a DC power supply (Acorn 180 manualp.11). Acorn's advice is to keep the mains switched on and the lift parked on its charge points. If you call it with a remote, do not leave it part way up the stairs unless there is an intermediate charge point to send it to (p.15).
When it is not charging, A1 flashes and the lift beeps. On page 11 Acorn describes the pattern: intermittent beeps for about 60 seconds, then hibernation, with a beep every 20 seconds and the display going dark. Using the controls or a remote wakes it, and the manual then says to park it on a charge point (p.20). If the mains has been off and the batteries have run down, let them recharge before using the lift; with E7 showing it will only go down, so bring it to the nearest charging station. Acorn beeping lists every beep from both Acorn manuals.
On batteries the 180 manual says what the 130's does: a power cut leaves the lift working for several journeys, but if it goes on long enough the batteries become too low to recharge, and then an engineer has to replace them, outside the manufacturer's warranty and at a charge. So "Acorn 180 battery replacement" is an engineer's visit; keeping the lift powered and parked is the owner's side of it. Battery replacement compares the makers.
The F7 warning
F7 is the one symbol in the 180's table that comes with a "do not". The manual does not say what F7 means on this model. It says that while F7 shows, the hand winder must not be used in the down direction, because that could damage the lift, and that you should contact your stairlift supplier immediately (Acorn 180 manualp.16). Hand winding means opening a cover on top of the carriage, and this guide leaves it to engineers in every case.
Remote controls
The 180's handset has an up and a down arrow, and the lift must be switched on with the seat facing forward before a remote will work. Holding a button sends the lift to the end of its travel, and the up button sends it to its autopark position (Acorn 180 manualp.15). The handset runs on a 9 volt PP3 battery, which Acorn recommends replacing every year; its battery cover slides off the back, and Acorn warns that a battery fitted the wrong way round can damage the remote. Remote not working has the other makes.
If it stops with you on it
Hurt, or cannot get off safely: call 999
The steps below are Acorn's, for a person who is safe and able.
Stay calm with both arms down, release the direction controller and press it again in the opposite direction (Acorn 180 manualp.18). Acorn's general rule is not to get off until the lift has reached the top or bottom of the stairs (p.10). If getting off part way cannot be avoided, the manual says to swivel the seat towards the stairs with the lever at the side of the seat, check it has locked, and only then undo the belt (p.19). If the lift will not run at all, the manual's last word is to contact your authorised dealer (p.17). There is more on this on the stuck on the stairs page.
No reset in the 180 manual
Unlike the 130's, the 180's user manual gives owners no reset procedure. The checks it does give are the ones above: the mains, the charge points, the seat, the arms and anything in the way. If those do not clear a symbol, the next step is the dealer or an engineer. The reset page explains which makers do publish a reset.
The manual itself
Acorn's 180 user manual is a multilingual PDF on Acorn's own website; English runs to printed page 25, and its wiring diagram and circuit-board pages are for engineers. The manual finder links Acorn's copy and the edition checked. This page covers faults only; it was written from that copy on the date shown above.
Where this comes from
Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.