The four beeps, and which are good news
| What you hear | Acorn 130 | Acorn 180 |
|---|---|---|
| One beep as the lift parks | It has reached a charge point and is charging (p.18). Good news. | Not described in the 180 manual. |
| A beep when you press the armrest control | The command has been received (p.11). No beep means look at the display. | Not described in the 180 manual. |
| Beeping while parked, display showing A1 | Parked off a charge point and not charging (p.24). | Batteries not charging; A1 flashes (pp.11 and 16). |
| About a minute of beeping, then occasional beeps | Sleep mode after a power failure or parking off a charge point: two beeps roughly every 40 seconds (p.22). | Hibernation: a beep every 20 seconds and a dark display (pp.11 and 20). |
| An alarm, display showing F5 | Battery flat (p.27). | Battery flat (p.16). |
When it will not stop beeping
A parked Acorn that keeps beeping is, by both manuals, a lift that is not being charged. The cause is one of three things: the chair is not on a charge point, the mains supply to the lift is off, or the batteries have run so low that the flat-battery alarm has started. Work through them in that order.
- Move it onto a charge point. On a 130 with a standard rail, the charge points are at the top and bottom, where the lift stops on its own; listen for the single beep. On a 180 they are at the top and bottom, plus an intermediate point if a hinge is fitted (Acorn 180 manualp.11). If the lift is asleep, using the paddle or a remote wakes it first.
- Check the mains. Acorn wants a socket used only by the stair lift, left plugged in and switched on (Acorn 130 manualp.18). A switched-off socket or spur, or a power cut, starts the beeping just as surely as parking in the wrong place.
- On a 130, check the battery isolation switch. It sits on the wall side or rear of the carriage cover and must stay on; off, the batteries lose their charge (p.10).
- If the alarm is F5, press the armrest control or the remote once to silence it, then take the lift down to the nearest charge point to recharge. The 130 manual adds: do this when E7 shows.
If the lift is on its charge point, the mains is on and it still beeps with A1 showing, Acorn's manuals give no further owner step. That is the point to call the dealer or an engineer: something in the charging system is not working. The C7, C8 and C9 codes on a 130 are the charger faults Acorn names, all marked for its authorised dealer. The full rows are on the Acorn error codes page.
Beeping after a power cut
Both manuals say an Acorn keeps working for several journeys on its batteries when the mains fails, then stops when they are spent. While it is without power it also behaves like a lift parked off its charge point: the warning beeps, then the sleep-mode beeps. When the power returns, wake it and park it on a charge point. The 180 manual adds a sensible step: if the batteries have lost their charge, let them recharge before using the lift again (Acorn 180 manualp.11). After a power cut covers the other makes.
When beeping becomes a battery problem
A lift left beeping for long enough runs its batteries down. Both Acorn manuals warn that batteries left without power long enough can become too low to recharge, and then have to be replaced by an engineer, outside the warranty and as a chargeable job. That is the strongest reason not to silence the beeping and walk away. If E7 or F5 keeps coming back after full charges, the batteries themselves may be the problem: see stair lift battery problems.
No beep at all
Silence can be a clue too. On the 130 the manual expects a beep each time the paddle is pressed; if there is none, it says to check the display code (Acorn 130 manualp.11). A dark display with no beep usually means the lift has no power or is in sleep mode, and the check for that is the battery isolation switch and a press of the paddle. For other makes' beeps, see stair lift beeping; for everything Acorn, the Acorn page.
Where this comes from
Each meaning, check and number above is taken from the documents listed here, opened on the maker's own website. Page numbers in the text are the numbers printed in each manual. How the makers' documents are checked.